X-axis Stepper Motor Cable Replacement
Hi all! I ran into an issue where my x-axis isn’t moving at all & after running a few troubleshoot tests I believe the cables are fried & need to be replaced. I think the cables may have hit the bed & gotten stuck on the corner because it was jammed on the last print & may have burnt the cables. Does anyone know how to replace them or where on the motherboard they’re located? After tracing I believe theyre connected with the extruder cables but i dont know which ones would be the motor & how to replace them. Thanks in advance!
Hi all! I ran into an issue where my x-axis isn’t moving at all & after running a few troubleshoot tests I believe the cables are fried & need to be replaced. I think the cables may have hit the bed & gotten stuck on the corner because it was jammed on the last print & may have burnt the cables. Does anyone know how to replace them or where on the motherboard they’re located? After tracing I believe theyre connected with the extruder cables but i dont know which ones would be the motor & how to replace them. Thanks in advance!